Article Per Year (5 Year)
p-Index From 2021 - 2026
1.235
P-Index
This Author published in this journals
All Journal Reaktor Jurnal Presipitasi : Media Komunikasi dan Pengembangan Teknik Lingkungan Journal of Engineering and Technological Sciences Chemistry Indonesian Journal of Chemical Research Bulletin of Chemical Reaction Engineering & Catalysis Journal of Engineering and Technological Sciences
Harimawan, Ardiyan
Department Of Chemical Engineering, Institut Teknologi Bandung
Aerospace Engineering Agriculture, Biological Sciences & Forestry Automotive Engineering Biochemistry, Genetics & Molecular Biology Chemical Engineering, Chemistry & Bioengineering Chemistry Civil Engineering, Building, Construction & Architecture Control & Systems Engineering Earth & Planetary Sciences Electrical & Electronics Engineering Energy Engineering Environmental Science Materials Science & Nanotechnology

Published : 15 Documents Claim Missing Document
Claim Missing Document
Check
Articles

Found 15 Documents
Search

 1   2 
Dynamic and Steady Model Development of Two-Chamber Batch Microbial Fuel Cell (MFC) Ardiyan Harimawan
Reaktor Volume 21 No.4 December 2021
Publisher : Dept. of Chemical Engineering, Diponegoro University

Show Abstract | Download Original | Original Source | Check in Google Scholar | DOI: 10.14710/reaktor.1.1.160-169

Abstract

As an alternative source of renewable energy that has piqued researchers’ interest, Microbial Fuel Cell’s (MFC) limitation of low power density requires further development. Various factors affect the performance, but performing all will be costly and time-consuming. Through a combination of dynamic and steady-state mathematical model modified from past research, effect of microbe types towards dynamic biofilm formation and stead-state OCV can be observed, followed by steady-state simulation to determine maximum power density and its’ corresponding voltage. Similarity with previous research has been observed, with maximum OCV of 838.93 mV achieved by heterotrophic biomass in 75-100 hours with biofilm thickness of 2.087 x 10-4 m, while generating maximum power density of 2050.12 mW//m2 and voltage of 408.16 mV. Lowest OCV value of 838.76 mV was observed in C. sporogenes in 450-475 hours with a biofilm thickness of 2.079 x 10-4 m, while the lowest value of maximum power density was observed in anaerobic microbial communities at 8.48 mW/m2 with voltage of 90.43 mV. Furthermore, it has been observed that variations with higher  and lower  results in higher stead-state OCV in the shortest amount of time, while increasing power density and its’ corresponding voltage. @font-face {font-family:"Cambria Math"; panose-1:2 4 5 3 5 4 6 3 2 4; mso-font-charset:0; mso-generic-font-family:roman; mso-font-pitch:variable; mso-font-signature:-536869121 1107305727 33554432 0 415 0;}@font-face {font-family:Calibri; panose-1:2 15 5 2 2 2 4 3 2 4; mso-font-charset:0; mso-generic-font-family:swiss; mso-font-pitch:variable; mso-font-signature:-469750017 -1073732485 9 0 511 0;}p.MsoNormal, li.MsoNormal, div.MsoNormal {mso-style-unhide:no; mso-style-qformat:yes; mso-style-parent:""; margin:0cm; mso-pagination:widow-orphan; font-size:12.0pt; font-family:"Times New Roman",serif; mso-fareast-font-family:"Times New Roman"; mso-ansi-language:EN-US;}.MsoChpDefault {mso-style-type:export-only; mso-default-props:yes; font-size:10.0pt; mso-ansi-font-size:10.0pt; mso-bidi-font-size:10.0pt; font-family:"Calibri",sans-serif; mso-ascii-font-family:Calibri; mso-fareast-font-family:Calibri; mso-hansi-font-family:Calibri; mso-ansi-language:IN; mso-fareast-language:IN;}div.WordSection1 {page:WordSection1;}
Biofilm Formation and Bio Corrosion of Carbon Steel in Diesel-Biodiesel Storage Tank Aida Nur Ramadhani; Ardiyan Harimawan; Hary Devianto
Jurnal Presipitasi : Media Komunikasi dan Pengembangan Teknik Lingkungan Vol 18, No 1 (2021): March 2021
Publisher : Universitas Diponegoro

Show Abstract | Download Original | Original Source | Check in Google Scholar | Full PDF (1651.131 KB) | DOI: 10.14710/presipitasi.v18i1.45-55

Abstract

Biodiesel is potential to blend with petroleum diesel as an alternative blended fuel. Biodiesel is usually stored in carbon steel storage tank which easily corroded by microorganisms. Microorganisms can use blended fuels as carbon source and water from biodiesel which is hygroscopic for growth and metabolism. Thus, degradation of fuel may occur and lead to biocorrosion by microorganisms such as Bacillus megaterium. This research was conducted to determine the effect of biodiesel concentration of blended fuel on biofilm formation and biocorrosion by Bacillus megaterium. The experiments were carried out by immersing carbon steel specimens in immersion medium for 21 days with variation of biodiesel concentration (B0, B20, B30, and B100). Biofilms that form on the metal surface cause areas with non-uniform oxygen concentrations and form anodic/cathodic conditions, raised to potential differences and biocorrosion occurred. The average corrosion rates were 0,035 ± 0,03; 0,533 ± 0,33; 0,642 ± 0,28; 0,109 ± 0,04 mm/year achieved by B0, B20, B30 and B100 respectively. These rates increased when compared to the control medium. Microorganism activity also caused damage to the metal surface by forming pitting corrosion on B30 and B100.
Produksi Ekstrak Bioaktif Untuk Aditif Pangan Dari Limbah Kulit Buah Naga: Pengaruh Metode Pre-Treatment Dan Ekstraksi Shofinita, Dian; Bindar, Yazid; Jaelawijaya, Arwinda Aprillia; Harimawan, Ardiyan; Fawwaz, Mifta
Indonesian Journal of Chemical Research Vol 8 No 1 (2020): Edisi Bulan Mei (Edition for May)
Publisher : Jurusan Kimia, Fakultas Sains dan Teknologi, Universitas Pattimura

Show Abstract | Download Original | Original Source | Check in Google Scholar | DOI: 10.30598/ijcr.2020.8-dia

Abstract

Dragon fruit is one of the tropical fruits can be grown in Indonesia. The skin of dragon fruit, which is accounted for 30-35% of the whole fruit usually thrown away as waste. This study aims to produce a bioactive extract from extraction of dragon fruit skin that is rich in phenolic and pigment compounds then it used as food additives. The variation that was used in this study includes the application of drying as pre-treatment of dragon fruit skin and the extraction methods (maceration and Soxhlet extraction). The obtained extracts were evaluated for the amount of total phenolic compounds and pigments (anthocyanin and betacyanin). Drying of dragon fruit skin was found to yield lower amounts of bioactive materials, which may occur due to the thermal degradation even though a low drying temperature was used. In addition, the maceration method was found to give a higher amount of bioactive materials compared with the Soxhlet method. The extraction with the highest yield of bioactive materials was obtained by the use of fresh dragon fruit skin and maceration for 240 minutes, which gave amounts of anthocyanin, betacyanin, and total phenolic compounds of 0.08, 0.04, dan 0.35 mg/g fresh dragon fruit skin, respectively.
Novel Study of Reaction Kinetics and Mass Transfer in Bioreactor Modelling: Prediction of Bioethanol Fermentation Performance by Saccharomyces cerevisiae on Continuous Fixed Bed Biofilm Plug Flow Reactor Aslan, Christian; Devianto, Hary; Wonoputri, Vita; Harimawan, Ardiyan
Bulletin of Chemical Reaction Engineering & Catalysis 2024: BCREC Volume 19 Issue 4 Year 2024 (December 2024)
Publisher : Masyarakat Katalis Indonesia - Indonesian Catalyst Society (MKICS)

Show Abstract | Download Original | Original Source | Check in Google Scholar | DOI: 10.9767/bcrec.20230

Abstract

Bioethanol implementation as a renewable fuel has yielded economic, social, and environmental benefits, including reduced fossil fuel consumption, enhanced energy diversity and supply security, lower greenhouse gas emissions, and support for agricultural communities. These impacts underscore the importance of advancing innovation and optimizing processes to increase bioethanol production. Therefore, basic knowledge of chemical engineering in bioethanol fermentation is important to be learnt as a preliminary study, such as reaction kinetics and transport phenomena. This work studies the reaction kinetics and mass transfer in continuous fixed bed biofilm plug flow reactor modelling to predict anaerobic Saccharomyces cerevisiae fermentation performance, which is still not studied comprehensively. This modelling provides an overview of the influence of various independent variables, namely temperature, initial substrate concentration, cell concentration, superficial flow rate, reactor diameter, and solid particle diameter on various dependent variables, namely final product concentration, residence time, reactor length, reactor volume, product productivity, and pressure drop. The most sensitive parameters related to product productivity are temperature and cell concentration, so in its implementation, the temperature must be controlled at its optimum temperature, and the inoculum must be prepared with high cell concentration. For the next study, it is recommended to study the optimization of reactor design and operation (i.e. the pumping system, cooling system, and pH control of the reactor) and the implementation of the reactor on the plant scale. Copyright © 2024 by Authors, Published by BCREC Publishing Group. This is an open access article under the CC BY-SA License (https://creativecommons.org/licenses/by-sa/4.0).
The Effect of Illumination, Electrode Distance, and Illumination Periods on the Performance of Phototrophic Sediment Microbial Fuel Cells (PSMFCs) Harimawan, Ardiyan; Devianto, Hary; Khodiyat, Nicholas; Gatalie, Kreszen Livianus; Aslan, Christian
Journal of Engineering and Technological Sciences Vol. 56 No. 1 (2024)
Publisher : Directorate for Research and Community Services, Institut Teknologi Bandung

Show Abstract | Download Original | Original Source | Check in Google Scholar | DOI: 10.5614/j.eng.technol.sci.2024.56.1.1

Abstract

Microbial fuel cells (MFCs) can potentially be used to overcome issues with battery powered light buoys and their frequent maintenance. In this study, a phototrophic sediment microbial fuel cell (PSMFC) was chosen, as the microalgae provide oxygen to be reduced on the cathode and to release the necessary nutrients for the bacteria on the anode. To achieve this, we studied the effect of illumination, the period of the illumination, and the distance between 9-cm2 stainless steel mesh electrodes on the performance of the MFC. The illuminated cells were able to produce higher OCP (max. 205.2 mV) and higher power density (max. 0.68 mW/m2). However, the highest current was achieved during the unilluminated variation (max. 5.3 μA unilluminated and 3.3 μA illuminated). Prolonged illumination produced a higher OCP, current, and power density. A longer electrode distance produced a higher OCP, power density, and current. SEM analysis showed that biofilm formation tended to be scattered at lower electrode distance and more clumped (filling the anode area) at higher electrode distance. Through FTIR analysis, it was found that all MFC variations had the same organic matter, but a more concentrated organic content was found in the MFC at longer electrode distances.
Co-Authors Abdu Ravi Zakaria Aida Nur Ramadhani Al-Aziz, Rd. Habib R. M. T. Aslan, Christian Awalina Satya Bork Ilsemann Dian Shofinita Dianika Lestari Diky Mudhakir Dwi Rokhmat Setiawan Fawwaz, Mifta Gadis Sri Haryani Gatalie, Kreszen Livianus Hary Devianto Ignatius Chandra Kurniawan Ilsemann, Bork Jaelawijaya, Arwinda Aprillia Josephine Christine Utomo Khalisa Putri Aqilah Khalisa Putri Aqilah Khodiyat, Nicholas Melia Laniwati Mike Reich Muhamad Insanu Pusparizkita, Yustina Metanoia Rd. Habib R. M. T. Al-Aziz Reich, Mike Salsafia Putri Salsafia Putri Satya, Awalina Schmahl, Wolfgang Setiadi, Tjandra Shelly Shelly Shofinita, Dian Shofinita, Dian Sri Haryani, Gadis Vita Wonoputri Wolfgang Schmahl Yazid Bindar Yustina Metanoia Pusparizkita