Claim Missing Document
Check
Articles

Found 2 Documents
Search
Journal : Jurnal JEETech

Pengaturan Jarak Bola (Sphere Gap) Pembangkitan Tegangan Tinggi Impuls Secara Semi Otomatis Sonong, Sonong; Yusuf Yunus, Muhammad; Marhatang, Marhatang; Saini, Makmur; Nawir, Herman; Ruswandi Djalal, Muhammad
Jurnal JEETech Vol. 4 No. 1 (2023): Nomor 1 May
Publisher : Universitas Darul Ulum

Show Abstract | Download Original | Original Source | Check in Google Scholar | Full PDF (578.625 KB) | DOI: 10.32492/jeetech.v4i1.4101

Abstract

An overhaul is a process of dismantling a problematic engine so that it can be examined more thoroughly. During the overhaul, the problematic engine components are replaced. The overhaul of the sphere gap setting of the semi-automatic high impulse voltage generation is also intended to maximize the K3 system and the level of accuracy when conducting research on impulse voltage generation. The current condition after the occurrence of damage to the automatic sphere gap adjustment machine. The sphere gap setting is done manually, causing the desired ball gap distance to be not very accurate, and the risk of work accidents is higher in the high voltage laboratory. In the first stage of work, an inspection and measurement were carried out to replace the capacitor and limit switch components because they could no longer be used. As well as improvements to the electromagnetic brake components. From the test results, it was found that the distance measurement was as expected and it can be proven that after an overhaul, the semi-automatic spacer can function normally again so it can make it easier to conduct high voltage impulse research. In addition, from a security point of view, it is better because the spacing between the balls is done outside the high-voltage impulse generation cage
Analisis Pemasangan Power System Stabilizer Pada Single Machine Infinite Bus Untuk Kondisi Variasi Beban Ruswandi Djalal, Muhammad; Saini, Makmur; Shiddiq Yunus, A.M
Jurnal JEETech Vol. 3 No. 2 (2022): Nomor 2 November
Publisher : Universitas Darul Ulum

Show Abstract | Download Original | Original Source | Check in Google Scholar

Abstract

Changes in the load on the electric power system suddenly cause dynamic disturbances. The disturbance causes the stability of the generator to be disturbed, because the generator does not respond to the disturbance quickly. This causes oscillations in the generator in the form of oscillations of frequency and rotor angle. One of the additional control equipment that can increase the stability of a generator is the Power System Stabilizer (PSS). With the PSS installation, the optimal frequency response and rotor angle of the SMIB system are obtained, indicated by the minimum system overshot response. The controller is able to provide stability so that overshoot oscillations can be suppressed, as well as faster settling time performance for the system to reach steady state conditions. To test the stability of the SMIB system, a case study of adding and subtracting loads is used, with the proposed control method using PSS.