Claim Missing Document
Check
Articles

Found 2 Documents
Search
Journal : Journal of Educational Engineering and Environment

Implementation of Ammonia (NH3) Gas Level Detection Tool in the Shrimp Processing Industry Sih Harsanti, Restiani; Mustika Yasi, Ratna
Journal of Educational Engineering and Environment Vol. 2 No. 1 (2023): Journal of Educational Engineering and Environment
Publisher : Fakultas Teknik Universitas PGRI Banyuwangi

Show Abstract | Download Original | Original Source | Check in Google Scholar | DOI: 10.36526/jeee.v1i2.2853

Abstract

Air contaminated with ammonia can cause respiratory problems, ammonia is colorless but has a pungent odor and is corrosive and highly toxic even at low concentrations. When ammonia enters the atmosphere and combines with air pollutants, especially nitrogen and sulfur oxide compounds from nearby vehicles, power plants and factories, it forms PM 2.5 which can be inhaled so that it can penetrate deeper into the lungs, increasing the risk of disease in the lower respiratory tract. lower. This research focuses on the implementation of an ammonia gas detector in a room that functions to detect air imbalances. This serves to overcome air pollution to employees who are in the shrimp factory production room, with this tool it can provide an early warning of excess ammonia gas in the shrimp factory production room to produce output. The ammonia gas detector in the industrial production room of the shrimp factory is based on ATMega 328P. The results showed that the average ammonia gas content in the storage room was within normal limits. The results showed that the average ammonia gas content in the storage room was within normal limits. However, the concentration of NH3 content can be increased by several other factors including the length of time of storage and the volume of shrimp in the storage room. The concentration of NH3 in the air ranges from 3-8 ppm in the shrimp storage room.
Viscosity Test as an Initial Parameter for Handling B3 Liquid Waste in Fuel Restiani Sih Harsanti; Reny Eka Evi Susanti; Ratna Mustika Yasi
Journal of Educational Engineering and Environment Vol. 2 No. 2 (2023): Journal of Educational Engineering and Environment
Publisher : Fakultas Teknik Universitas PGRI Banyuwangi

Show Abstract | Download Original | Original Source | Check in Google Scholar | DOI: 10.36526/jeee.v2i2.3307

Abstract

Sludge oil is also defined as oil sludge that contains heavy metal compounds with characteristics that are difficult to clean with air. Therefore, oil sludge processing must follow the established B3 Waste Processing regulations. This research aims to provide information on viscosity tests as an initial parameter for B3 waste management methods. This research uses a distillation method using distilled water with a solvent volume ratio of 1:1 and 2:1 and a redwood viscosity test to obtain the viscosity value of the sample. The results of the research show that the effect of temperature on waste viscosity is negative exponential, while the effect of the distillation volume ratio on the viscosity of the sample volume compared to the solvent is that the viscosity value is greater.